How to change water pump in Morphy Richards steam generator iron.

How to change water pump in Morphy Richards steam generator iron.

If you visit my website it means tha your Morphy Richards steam generator is no working properly.

You can fix steam generator iron of other makers, they are similar to repair.

I am qualified electrician, have fixed 100's of these irons and sold 100's of pumps.

First of all make sure your iron is unpluged and cool.

At the bottom you will need to unscrew 5 screws, then split into halfs.

Top half is attached to botton by wires at the switch end.

Bottom of steam generator iron

Water pump is placed between boiler and water tank, green item with 3 wires.

Where is water pump in Morphy Richards steam generator irons.

To disconnect wires you will need screw driver or something similar as there is protection on the connectors, won't come off easy. Need to push a middle of the connector to release it and then pull it.

Water pump in Morphy Richards steam generator iron.

Lift up white cable tie.

Steam Generator faulty pump replacement.

Move white rubber ring out of the black end of the pump.

Move white rubber ring out of the black plastic part of the pump.

Disconnect hose from white tower connected to water tank.

Pull this hose throught white ring.

Put back on cable tie on neutral connector of the pump.

Hold white plastic ring and pull off pump, place new pump into that hose, but make sure you pushed to the end.

Place inlet hose back through white rubber ring and connect to white tower connected to water tank.

Connect wires to the pump, make sure wires are away from holes where screw comes through.

The best way put back cable tie on the white tower, picture above.

Put back whole base and test it.

Leave a Reply

* Name:
* E-mail: (Not Published)
   Website: (Site url withhttp://)
* Comment:
Type Code
Visit Bargains-zone.co.uk on ShopMania